Victron Blue Smart IP67 Charger 12 volt 7 amp

The battery is charged, smartly... to perfect condition
The seven-step charging algorithm gets the best out of your battery. The charger gives the battery the power it needs, maintains its health, ensures better performance... and a longer life.

Recovery of deeply-discharged 'dead' batteries
Unlike other brands, the Blue Smart IP67 Charger Waterproof will attempt to recharge a deeply-discharged battery by force-feeding it with a low current. Normal charging will then be resumed as soon as there is sufficient voltage across the battery terminals.

Check the status of your battery remotely
Blue Smart IP67 Charger Waterproof is equipped with built-in Bluetooth, so the status of the charger and the battery can be checked on a smartphone, tablet or laptop. All settings of the charger can be configured with the VictronConnect app.

Start Inerrupt (si models only)
si is a second current limited output which is always powered as long as AC voltage is present on the input. This output can for example be used to prevent starting of a vehicle before unplugging the battery charger

Bluetooth Smart enabled
The Blue Smart IP67 Charger is the wireless solution to monitor voltage and current, to change settings and to update the
charger when new features become available.
With Bluetooth, the functionality of the IP67 charger is enhanced and is similar to that of our IP22 and IP65 chargers.
Completely encapsulated: waterproof, shockproof and ignition protected
Water, oil or dirt will not damage the Blue Smart IP67 Charger. The casing is made of cast aluminium and the electronics are
moulded in resin.
The highest efficiency ever!
Setting a new industry standard: with 92% efficiency or better, these chargers waste three to four times less heat.
And once the battery is fully charged, power consumption reduces to less than a Watt, some five to ten times better than
the industry standard.
Adaptive 5-stage charge algorithm: bulk absorption recondition float storage
The Blue Smart Charger features a microprocessor controlled adaptive battery management. The adaptive feature will
automatically optimise the charging process relative to the way the battery is being used.
Storage Mode: Less maintenance and aging when the battery is not in use
The storage mode kicks in whenever the battery has not been subjected to discharge during 24 hours. In the storage mode
float voltage is reduced to 2,2 V/cell (13,2 V for a 12 V battery) to minimise gassing and corrosion of the positive plates.
Once a week the voltage is raised back to the absorption level to equalize the battery. This feature prevents stratification
of the electrolyte and sulphation, a major cause of early battery failure.
Also charges Li-ion batteries
Li-ion batteries are charged with a simple bulk absorption float algorithm.
Fully discharged battery recovery function
Will initiate charging even if the battery has been discharged to zero volts.
Will reconnect to a fully discharged Li-ion battery with internal disconnect function.
Protected against overheating
Can be used in a hot environment such as a machine room. Output current will reduce as temperature increases up to 60°C,
but the charger will not fail.
Two LEDs for status indication
Yellow LED: bulk charge (blinking fast), absorption (blinking slow), float (solid), storage (off)
Green LED: power on

Available Varients to Order.  For further information contact [email protected]

• 792-BPC120713006 - 12V/7A
• 792-BPC121313006 - 12V/13A  (Normally in stock)
• 792-BPC121713006 - 12V/17A
• 792-BPC122513006 - 12V/25A
• 792-BPC122514006 - 12V/25A (si)
• 792-BPC240513006 - 24V/5A
• 792-BPC240813006 - 24V/8A
• 792-BPC241213006 - 24V/12A
• 792-BPC241214006 - 24V/12A (si)